Commissioning; General Procedure - WAGO 750-370 Manual

WAGO-I/O-System 750
750-370 PROFINET IO Fieldbus Coupler
Pos : 68 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Inbetri ebnehmen - Konfigurier en - Parametri eren - Bedienen/In Betri eb nehmen - Ü bersc hrift 1 @ 4\mod_1240901452750_21.doc x @ 31570 @ 1 @ 1
8

Commissioning

Pos : 69.1 /Serie 750 (WAGO-I/O-SYST EM)/In Betrieb nehmen/Fel dbus knoten i n Betrieb nehmen/PROFINET IO/In Betrieb nehmen ( 750-370) @ 23\mod_1433167672587_21.doc x @ 183168 @ 2222 @ 1
8.1

General Procedure

If you have assembled the requested peripheral of the fieldbus coupler using the
corresponding I/O modules and established the required power supply
connections you can proceed with commissioning of the node within IOC
engineering. The specific procedure depends on the IOC configuration software
used.
Therefore, this section does not describe the use of any specific application in
terms of the configuration software. Instead, this section provides a brief overview
of the process and steps required for commissioning.
Subsequent sections provide the details of each step for commissioning.
More Information on commissioning!
Specific step-by-step instructions are available in the quickstart guide for the
PROFINET IO fieldbus coupler.
How an installed and connected fieldbus coupler is configured to the point that it
is ready for use is described based on the configuration software.
You can download the quickstart guide from the WAGO Internet site at:
www.wago.com.
Manual
Version 2.0.0
Commissioning 91