Pos : 71.14 /Serie 750 ( WAGO-I/O-SYST EM)/Web-Bas ed-M anagement-Sys tem WBM/Seite Sec urity/Security - Ei nleitung @ 4\mod_1242630881437_21.doc x @ 33436 @ 2 @ 1

9.4

Security

Use the "Security" HTML page with passwords to set up read and/or write access

for various user groups to protect against configuration changes.

Passwords can only be changed by "admin" and after software reset!

The "admin" user and associated password are required to change passwords.

Press the [Software Reset] button to restart the software for the setting changes to

take effect.

Note password restrictions!

The following restriction is applied for passwords:

•

Max. 32 characters inclusive special characters.

Pos : 71.15 /Serie 750 ( WAGO-I/O-SYST EM)/Web-Bas ed-M anagement-Sys tem WBM/Seite Sec urity/Hi nweis : N ach Softwar e-Res et Zugriff er neuer n! @ 6\mod_1260540394978_21.doc x @ 47059 @ @ 1

Renew access after software reset!

If you initiate a software reset on this page, then the fieldbus coupler/controller

starts with the configurations previously loaded into the EEPROM and the

connection to the browser is interrupted.

If you changed the IP address previously, you have to use the changed IP address

to access the device from the browser.

You have not changed the IP address and performed other settings; you can

restore the connection by refreshing the browser.

Pos : 71.16 /Serie 750 ( WAGO-I/O-SYST EM)/Web-Bas ed-M anagement-Sys tem WBM/Seite Sec urity/Security - Bil d (750-370) @ 23\mod_1436523534612_21.doc x @ 185992 @ @ 1

Manual

Version 2.0.0

Configuring via the Web-Based Management System (WBM)

113

Table of Contents