Connecting A Conductor To The Cage Clamp; Figure 36: Connecting A Conductor To A Cage Clamp - WAGO 750-370 Manual

72 Connect Devices
Pos : 63.11 /Serie 750 ( WAGO-I/O-SYST EM)/Ansc hließ en/Leiter an CAGE CLAMP ansc hließ en (allgemein) - Ü berschrift 2 und T ext @ 3\mod_1225448660171_21.doc x @ 24928 @ 2 @ 1
6.3

Connecting a Conductor to the CAGE CLAMP

The WAGO CAGE CLAMP
finely stranded conductors.
Only connect one conductor to each CAGE CLAMP
Only one conductor may be connected to each CAGE CLAMP
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Exception:
If it is unavoidable to jointly connect 2 conductors, then you must use a ferrule to
join the wires together. The following ferrules can be used:
Length:
Nominal cross section
WAGO product:
1. For opening the CAGE CLAMP
above the connection.
2. Insert the conductor into the corresponding connection opening.
3. For closing the CAGE CLAMP
now clamped firmly in place.

Figure 36: Connecting a Conductor to a CAGE CLAMP

Pos : 64 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
®
connection is appropriate for solid, stranded and
8 mm
2
: 1 mm for 2 conductors with 0.5 mm
max.
216-103 or products with comparable properties
®
insert the actuating tool into the opening
®
simply remove the tool. The conductor is
WAGO-I/O-System 750
750-370 PROFINET IO Fieldbus Coupler
®
!
®
.
®
®
2
each
Manual
Version 2.0.0