Commissioning; General Notes; Opening The Housing - WAGO WINSTA 770 Manual

32

Commissioning

Pos : 56 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Inbetri ebnehmen - Konfigurier en - Parametri erenIn Betri eb nehmen - Ü bers chrift 1 @ 4\mod_1240901452750_21.doc x @ 31570 @ 1 @ 1
7 Commissioning
Pos : 57 /Serie 770 ( WINSTA-Boxen) /In Betri eb nehmen/In Betrieb nehmen 0770-0629/0130- 0000 @ 6\mod_1256801098019_21.doc x @ 43791 @ 222332333444443443443442 @ 1
7.1

General Notes

The sunblind box is equipped at the factory with the following configuration:
• Bus operation
• Sunblind function
• 1 minute runtime
• Bus failure monitoring OFF
• 4 groups: all motors are controlled individually
Changes to these settings will be explained below.
Only make the setting when the device is de-energized!
In order not to damage the sunblind box, settings on the box shall only be made
when it is de-energized.
Changes to the setting only become effective after a restart!
For safety reasons, a change to a setting may only be taken over after a restart of
the box. This takes place automatically when the sunblind box is supplied with
voltage again.
7.2

Opening the Housing

Only open the housing when it has been de-energized!
Always turn off the power supply to the device before opening the housing or
working on the device.
To open the box, insert a pointed object (e.g. a screwdriver) at the marked points
(A and B) in the recesses in the cover and lever the handle towards the middle of
the box (see box imprint). This unlocks the box and allows you to lift off the
cover.
770-629/130-000 WINSTA® Sunblind Box 4 Channel
Version 1.2.0, valid from HW/FW version XXXX0201XX
WAGO WINSTA® 770
Manual