Pos : 38.1 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Bedienel emente/F el dbus koppl er/-contr oller/DIP-Sc halter - Übersc hrift 3 @ 15\mod_1369661120678_21.doc x @ 120594 @ 3 @ 1

4.5.2

DIP Switch

Pos : 38.2 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Bedienel emente/F el dbus koppl er/-contr oller/DIP-Sc halter-Bild ( 8 ... 1 von oben nac h unten) Bilduntersc hrift: DIP-Sc halter @ 15\mod_1369661277690_21.doc x @ 120600 @ @ 1

Figure 26: DIP Switch

Pos : 38.3 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Bedienel emente/F el dbus koppl er/-contr oller/Adr ess wahlsc halter PR OFIN ET: D er Adr ess wahls chalter di ent z ur opt. Eins t. der Gerätenamen (750-370) @ 23\mod_1439380336349_21.doc x @ 188288 @ @ 1

The DIP switch can be used to assign a device name to the fieldbus coupler,

which can be selected from two pre-defined character strings and can be

instantiated each.

DIP switch settings only applied after reset!

Please note that any settings made are only applied during start-up, i.e. after

switching on the supply voltage (hardware reset) or in operation after software

reset. If one of the specified resets is not carried out, changes to the switch

settings are not applied during operation!

Pos : 38.4 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Bedienel emente/F el dbus koppl er/-contr oller/Adr ess wahlsc halterbesc hreibung - Koppl er (750- 370) @ 23\mod_1438867434350_21.doc x @ 187542 @ @ 1

WAGO-I/O-System 750

750-370 PROFINET IO Fieldbus Coupler

Manual

Version 2.0.0

Table of Contents