Table 56: Blink Code Table For The I/O Led Signaling, Error Code 2; 750-370 Profinet Io Fieldbus Coupler - WAGO 750-370 Manual

WAGO-I/O-System 750

750-370 PROFINET IO Fieldbus Coupler

Table 55: Blink Code Table for the 'I/O' LED Signaling, Error Code 1
Error code 1: "Hardware and configuration error"
Error
Argument
8
9
10
11
12
13
14
Pos : 75.12 /Serie 750 ( WAGO-I/O-SYST EM)/Diagnos e/F eldbus koppler/-c ontroll er/Bli nkc ode-Tabellen - F ehl erc ode 2...5 (750- 0333) @ 11\mod_1317133888384_21.doc x @ 79834 @ @ 1

Table 56: Blink Code Table for the I/O LED Signaling, Error Code 2

Error code 2: -not used-
Error
Argument
-
Manual
Version 2.0.0
Error Description Solution
Timeout during 1. Turn off the power supply for the node.
serial EEPROM 2. Replace the fieldbus coupler.
access. 3. Turn the power supply on again.
1. Turn off the power supply for the node.
Fieldbus coupler
2. Replace the fieldbus coupler.
initialization error
3. Turn the power supply on again.
Buffer voltage 1. Set the clock.
failure Real Time 2. Get the power supply for the fieldbus coupler for at least
Clock (RTC)
Fault when read 1. Set the clock.
access to the Real 2. Get the power supply for the fieldbus coupler for at least
Time Clock (RTC)
Fault when write 1. Set the clock.
access to the Real 2. Get the power supply for the fieldbus coupler for at least
Time Clock (RTC)
1. Set the clock.
Error clocks interrupt 2. Get the power supply for the fieldbus coupler for at least
1. Turn off the power for the node.
Maximum number of
2. Reduce the number of corresponding modules to a valid
gateway or mailbox
modules exceeded
3. Turn the power on again.
Error Description Solution
Not used
15 minutes to charge the Goldcap.
15 minutes to charge the Goldcap.
15 minutes to charge the Goldcap.
15 minutes to charge the Goldcap.
number.
Diagnostics
-
121