Firmware Update - WAGO 750-370 Manual

WAGO-I/O-System 750
750-370 PROFINET IO Fieldbus Coupler
7.9

Firmware Update

The device firmware is updated via the ETHERNET interface only and has to be
carried out using the "WAGO Ethernet Update" firmware update tool.
A firmware update is also available via the configuration interface using the tool
"WAGO FBC Update" possible.
Firmware update tool only available on request!
Please note that the "WAGO Ethernet Update" and "WAGO FBC Update"
firmware update tool is only available on request. Contact Technical Support by
e-mail at:
support@wago.com.
The steps required to update the firmware are explained in the "WAGO Ethernet
Update" online help or via e-mail technical support for the provision of "WAGO
FBC Update".
The following requirements must be met to successfully firmware update with the
firmware update tool "WAGO Ethernet Update":
• The fieldbus coupler has a valid device name.
The device name can be specified using a DCP service tool or via
available DIP switch.
• The fieldbus coupler has appropriate IP settings.
A DCP service tool can be used to make the IP settings or temporarily
using the address resolution of the connected IOX.
• The IP settings remain after restarting the fieldbus coupler as part of the
firmware update or are made available again.
After the required firmware has been uploaded to the fieldbus coupler, it is
checked for consistency and persistently stored. The firmware is applied
by restarting via "WAGO Ethernet Update". The tool then attempts to
initiate extraction of the internal file system for the web server. This
requires that the IP settings used previously are available.
If the device name or IP settings are no longer available after restarting
due to an only temporary assignment, they have to be reassigned to the
fieldbus coupler using the procedures mentioned above to successfully
complete the update process.
Manual
Version 2.0.0
Function Description 89