Standard Modul Parameters; Table 44: Default Module Parameters - WAGO 750-370 Manual

WAGO-I/O-System 750
750-370 PROFINET IO Fieldbus Coupler
Pos : 69.7 /Serie 750 (WAGO-I/O-SYST EM)/In Betrieb nehmen/Fel dbus knoten i n Betrieb nehmen/PROFINET IO/Par ametri erung - Modulparameter (750- 370) @ 23\mod_1433247912347_21.doc x @ 183220 @ 3333 @ 1
8.6.3

Standard Modul Parameters

Certain module properties of some I/O modules can be parameterized during
configuration. At present, this only applies to the output modules whose substitute
value behavior can be set independent of the modules used.

Table 44: Default Module Parameters

Attribute name
Substitute value
behavior of the outputs
Manual
Version 2.0.0
Attribute value Description
If the PROFINET IO Controller does not supply
valid output data for the module or the group of
modules, then
•
according to the
device settings*)
according to the •
referenced module
settings*)1)
Output states are set •
to 0.
Outputs maintain the •
last valid value.
Outputs take their •
substitute states.
*)
Default setting
1)
Digital modules whose process data has been allocated to their previous
slots implicitly take the substitute value strategy of the module on the
slot allocated.
Commissioning
the set strategy of the station substitute applies
(IO device).
the set strategy of the reference digital module
applies by which the output data has been
reserved. These settings apply to digital output
modules without process data. These are
characterized by a "*" after the item number.
all outputs are reset.
all outputs maintain the last valid value.
all outputs switch to their configured substitute
values.
99