WAGO 750-370 Manual page 206

206 Appendix
Table 173: Additional Error Information Error Type "Configuration Fault (0x0010)"
Fault type "Configuration fault (0x0010)"
Extended
fault type
0x0021
0x0024
0x0030
0x0031
0x0032
0x0033
0x0034
0x0035
0x0051
0x0060
0x0061
0x0062
0x0070
0x0071
0x0072
0x0080
0x0081
0x0090
0x0091
0x0092
0x0093
0x0094
0x0095
0x0096
0x0097
0x0098
0x0099
0x009A
0x009B
Additional Description
value
0xC0018021 The substitute value behavior for the output of the module is not
allowed.
0xC0018024 The reserved output parameters of the module have an invalid
value.
0xC0018030 The combination of input and diagnostics is not supported in the
process image.
0xC0018031 The combination of input and diagnostics is not allowed in the
process image.
0xC0018032 The bit offset for the output of the module is not allowed.
0xC0018033 The bit offset for the diagnostic of the module exceeds the
maximum offset.
0xC0018034 The reserved diagnostic parameters of the module have an
invalid value.
0xC0018035 The diagnostic connection of the module is aborted.
0xC001xx51 The reserved channel parameter of the module has an invalid
value.
0xC001xx60 The substitute value for the input channel of the module is not
allowed.
0xC001xx61 The substitute value for the input channel of the module exceeds
its maximum.
0xC001xx62 The substitute value for the input channel of the module falls
below its minimum.
0xC001xx70 The substitute value for the output channel of the module is not
allowed.
0xC001xx71 The substitute value for the output channel of the module
exceeds its maximum.
0xC001xx72 The substitute value for the output channel of the module falls
below its minimum.
0xC001xx80 The substitute value for the output channel of the module is not
allowed.
0xC001xx81 The connection of the channel diagnostics of the module is not
allowed.
0xC0018090 The status of the station during the configuration is not allowed.
0xC0018091 The length of the configuration data for the station is smaller
than expected.
0xC0018092 The length of the configuration data for the station is larger than
expected.
0xC0018093 The reserved station parameters (Table 0, register 0) have invalid
values.
0xC0018094 The reserved station parameters (Table 0, register 1) have invalid
values.
0xC0019095 The register access (Table 0, register 1) is not allowed.
0xC0018096 The setting of the diagnostic channel (Table 0, register 1) is not
allowed.
0xC0018097 The reserved station parameters (Table 0, register 2) have invalid
values.
0xC0018098 The setting for the internal data bus extension (Table 0, register
2) is not allowed.
0xC0018099 The reserved station parameters (Table 0, register 3) have invalid
values.
0xC001809A The connection for creating the process image (Table 0, register
3) is deactivated.
0xC001809B The algorithm for creating the process image (Table 0, register 3)
is not allowed.
WAGO-I/O-System 750
750-370 PROFINET IO Fieldbus Coupler
Manual
Version 2.0.0