30
System Description
Pos : 18.15.32 /Seri e 750 ( WAGO-I/O-SYSTEM)/Systembes chr eibung/Versorgung/F eldversorgung - Absic herung @ 3\mod_1232950081500_21.doc x @ 26692 @ 4 @ 1
3.6.3.2
Fusing
Internal fusing of the field supply is possible for various field voltages via an
appropriate power supply module.
Table 7: Power Supply Modules
Order No.
750-601
750-609
750-615
750-617
750-610
750-611
750-606
750-625/000-001 Supply Module 24 V DC, 1,0 A, Ex i (without diagnostics)
Figure 7: Supply Module with Fuse Carrier (Example 750-610)
Observe the maximum power dissipation and, if required, UL requirements!
In the case of power supply modules with fuse holders, you must only use fuses
with a maximum dissipation of 1.6 W (IEC 127).
For UL approved systems only use UL approved fuses.
In order to insert or change a fuse, or to switch off the voltage in succeeding I/O
modules, the fuse holder may be pulled out. In order to do this, use a screwdriver
for example, to reach into one of the slits (one on both sides) and pull out the
holder.
Field Voltage
24 V DC, Supply/Fuse
230 V AC, Supply/Fuse
120 V AC, Supply/Fuse
24 V AC, Supply/Fuse
24 V DC, Supply/Fuse/Diagnosis
230 V AC, Supply/Fuse/Diagnosis
Supply Module 24 V DC, 1,0 A, Ex i
WAGO-I/O-System 750
750-370 PROFINET IO Fieldbus Coupler
Manual
Version 2.0.0