Frequency Settings; Resetting The Cpu; Initial Settings - Icom ic-718 Instruction Manual

 Resetting the CPU
Before fi rst applying power, make sure all connections
required for your system are complete by referring to
Chapter 3. Then, reset the transceiver using the fol-
lowing procedure.
A resetting CLEARS all Memory channel program-
ming and returns all Quick Set mode and Initial Set
mode settings to their factory defaults.
q Make sure the transceiver power is OFF.
w While holding down [UP ∫] and [√ DN], hold down
[PWR] for 1 second to turn ON the power.
• The internal CPU is reset.
• The transceiver displays its initial VFO frequencies
when resetting is complete.
e All Quick Set mode and Initial Set mode settings
are returned to their default values. (p. 41)
 Initial settings
After resetting the transceiver, set the controls and
switches as shown in the fi gure below.
[POWER]: OFF
[AF]: Max. counter clockwise
Turn ON the power, then check the display. If any of
the following icons appear, turn them OFF as follows.
• Quick tuning step icon ("√"): Push [TS].
• 1 Hz frequency readout:
• RIT icon (" RIT RIT "):
• Split icon (" "):

FREQUENCY SETTINGS

[METER]: Po
[RF/SQL]: 12 o'clock
Hold down [TS] for 1
second.
( When Quick Tuning step
is OFF.)
Set the [RIT] control to
the center position.
Push [SPL].
[PWR]
In cooler temperatures, the LCD may appear dark
and unstable after turning ON the power. This is
normal and does not indicate any equipment mal-
function.
[NB], [COMP]: OFF
[P.AMP], [ATT]: OFF
[LOCK]: OFF
[RIT]: Center
[IF SHIFT]: Center
4
[Z DN] [UP Y]
15