Selecting An Operating Mode For The O3 Generator; Cnst (Constant); Bnch (Bench) - Teledyne T700 Operation Manual

Teledyne API – Model T700 Dynamic Dilution Calibrator

3.4.8. SELECTING AN OPERATING MODE FOR THE O3 GENERATOR

3.4.8.1. CNST (CONSTANT)

3.4.8.2. BNCH (BENCH)

Make sure that the T700 is
in standby mode.
Use these buttons
to select a control
mode for the O
Generator:
06873E DCN7106
The O generator can be set to operate in two different modes: Constant and Bench.
3
In this mode, the O output of the generator is based on a single, constant, drive voltage.
3
There is no Feedback loop control by the T700‟s CPU in this mode.
concentration control loop will use the photometer‟s O
The O
3
To select a default O generator mode, press:
3
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ
SETUP X.X
PRIMARY SETUP MENU
SEQ CFG
GAS
SETUP X.X
SOURCE GAS CONFIG
CYL USER
O3
SETUP X.X
O3 GAS CONFIG
ADJ PHOT
MODE
SETUP X.X O3 GEN MODE:REF
CNST REF BNCH
3
SETUP X.X
O3 GAS CONFIG
MODE ADJ PHOT
SETUP
CLK PASS MORE EXIT
EXIT
EXIT
ENTR EXIT
EXIT
Getting Started
measurement as input.
3
These buttons initiate
procedures for calibrating and
verifying the operation of the O
3
Generator and Photometer
(see Chapter 12)
EXIT discards the new
setting
ENTR accepts the
new setting
87