Adding Or Editing O Generator Calibration Points - Teledyne T700 Operation Manual

Teledyne API – Model T700 Dynamic Dilution Calibrator
7.4.2.2. Adding or Editing O
STANDBY
Make sure that the T700 is
in standby mode.
<TST
SETUP X.X
GAS
SETUP X.X
COMM FLOW
SETUP X.X
8
Toggle these buttons to
enter the correct
PASSWORD
DIAG
PREV
When a point is added to the table
its default condition is ON (enabled).
06873E DCN7106
Generator Calibration Points
3
To add a calibration point to the table or edit an existing point, press:
A-CAL=0.000 LPM
TST> GEN STBY SEQ
PRIMARY SETUP MENU
SEQ CFG CLK PASS MORE
SECONDARY SETUP MENU
VARS DIAG
ENTER PASSWORD
1 8 ENTR
SIGNAL I/O
NEXT ENTR
Toggle these buttons to the place in the
table where the point is to be added or
edited. New Points are inserted
BEFORE the displayed point.
Toggle these buttons to move
between calibration points
parameters
Toggle these buttons to set
the drive voltage
Toggle these buttons to set
the dwell time for the point.
NOTE
Toggle these buttons to set
the dwell time for the point.
SETUP
EXIT
Continue pressing NEXT until ...
EXIT
DIAG O3 GEN CALIBRATION
EXIT PREV NEXT
DIAG O3 GEN CALIBRATION
CAL PNTS
EXIT
DIAG O3GEN 1) 500 MV, 5.0 MIN, ON
PREV NEXT INS
DIAG O3GEN CAL. POINT DRIVE:0 MV
<SET SET> EDIT
DIAG O3GEN CAL. POINT DRIVE:0 MV
0 3 0
DIAG O3GEN CAL. POINT DRIVE:300 MV
<SET SET> EDIT
DIAG O3GEN CAL. POINT DURATION: 0.0 MIN
<SET SET> EDIT
DIAG O3GEN CAL. POINT DURATION: 0.0 MIN
0 5 .0
DIAG O3GEN CAL. POINT DURATION: 0.0 MIN
<SET SET> EDIT
DIAG O3GEN CAL. POINT DURATION: 0.0 MIN
<SET SET> EDIT
DIAG O3GEN CAL. POINT DURATION: 0.0 MIN
0 5 .0
Calibration and Verification
ENTR EXIT
EXIT
DEL EDIT PRNT EXIT
EXIT
0 ENTR EXIT
EXIT discards
the new setting
ENTR accepts
the new setting
EXIT
EXIT
ENTR EXIT
EXIT discards
the new setting
ENTR accepts
the new setting
EXIT
EXIT
EXIT discards
ENTR EXIT
the new setting
ENTR accepts
the new setting
211