Manually Configuring The Network Ip Addresses - Teledyne T700 Operation Manual

Communications Setup and Operation

5.4.1.1. Manually Configuring the Network IP Addresses

EXIT ignores the
180
There are several circumstances when you may need to manually set the Ethernet
configuration:

Your LAN is not running a DHCP software package,

The DHCP software is unable to initialize the calibrator‟s interface;

You wish to configure the interface with a specific IP address, such as for a
permanent Ethernet connection..
Manually configuring the Ethernet interface requires that you first turn DHCP to OFF
before setting the
MASK parameters:
STANDBY
<TST
SETUP X.X
GAS
SETUP X.X
COMM
SETUP X.X
SETUP X.X
SETUP X.X
SETUP X.X
Toggle to turn
DHCP ON/
OFF
SETUP X.X
ENTR accepts
the new setting
new setting
Teledyne API – Model T700 Dynamic Dilution Calibrator
INSTRUMENT IP,
A-CAL=0.000 LPM
TST> GEN STBY SEQ
PRIMARY SETUP MENU
SEQ CFG CLK PASS
SECONDARY SETUP MENU
VARS DIAG
FLOW
COMMUNICATIONS MENU
ID COM1 COM2
INET
ENTER PASSWORD:818
8 1 8
DHCP:ON
<SET SET>
EDIT
DHCP:ON
ON
DHCP:OFF
OFF
Continue to Step 2 Below
GATEWAY IP and
SETUP
EXIT
MORE
EXIT
EXIT
ENTR EXIT
EXIT
ENTR EXIT
ENTR EXIT
06873E DCN7106
SUBNET