Connecting The Control Inputs; Table 3-4: T700 Control Input Pin Assignments - Teledyne T700 Operation Manual

Teledyne API – Model T700 Dynamic Dilution Calibrator

3.3.1.4. Connecting the Control Inputs

Table 3-4: T700 Control Input Pin Assignments

CONNECTOR
Top
Bottom
BOTH
Top
Bottom
BOTH
06873E DCN7106
The calibrator is equipped with 12 digital control inputs that can be used to initiate
various user-programmable calibration sequences (see Section 4.3.1.5 for instructions on
assigning the control inputs to specific calibration sequences).
Access to these inputs is via two separate 10-pin connectors, labeled CONTROL IN,
that are located on the calibrator‟s rear panel.
INPUT
Can be used as either 6, separate on/off switches or as bits 1 through
1 to 6
6 of a 12-bit wide binary activation code.
Can be used as either 6, separate on/off switches or as bits 7 through
7 to 12
12 of a 12-bit wide binary activation code.
Chassis ground.
Input pin for +5 VDC required to activate pins 1 – 6. This can be from
U
an external source or from the "+" pin of the connector.
Input pin for +5 VDC required to activate pins 7 – 12. This can be
U
from an external source or from the "+" pin of the connector.
Internal source of +5V used to actuate control inputs when connected
+
to the U pin.
DESCRIPTION
Getting Started
39