Setting The Progress Reporting Mode For The Sequences; Table 4-10: Sequence Progress Reporting Mode - Teledyne T700 Operation Manual

Overview of Operating Modes and Basic Operation

4.3.1.7. Setting the PROGRESS Reporting Mode for the Sequences

Table 4-10: Sequence Progress Reporting Mode

MODE
STEP
PCT
ELAP
REM
This display only appears if there are no sequences currently
SETUP X.X
PREV NEXT
Scrolls back and forth between
existing sequences
8
126
As sequences run, the T700 calibrator reports progress by displaying a message in the
MODE field of the front panel display (See Figure 3-1). There are several types of
report modes available (see Table 4-10).
Shows the progress as the sequence name and step number. This is the traditional display.
Example: Progress for a sequence named "SO2_Test" would appear as "SO2_Test-2",
indicating that it is currently executing step 2.
Shows the progress as a percent (0–100%) of each duration step.
Example: "SEQ 48%"
Shows the progress as time elapsed in hours, minutes and seconds, counting upward from 0.
Example: "T+01:30:25" (i.e. 1 hour, 30 minutes, 25 seconds have elapsed)
Shows the progress as time remaining in hours, minutes, and seconds remaining, counting
downward to 0.
Example: "T-01:30:25" (i.e. 1 hour, 30 minutes, 25 seconds are remaining)
To select a PROGRESS report mode, press:
Make sure that the T700 is
in standby mode.
programmed into the T700.
OTHERWISE ...
[NAME] [X]
1) SEQ , STEPS
INS DEL EDIT PRNT
Deletes the sequence shown Edits the sequence shown
in the message field in the message field
Use these buttons to
choose a PROGRESS
Teledyne API – Model T700 Dynamic Dilution Calibrator
DESCRIPTION
STANDBY
<TST TST>
SETUP X.X PRIMARY SETUP MENU
GAS SEQ
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT
SETUP X.X
EXIT
SETUP X.X NAME:0
SET>
Continue pressing SET> until ...
STEPS Submenu
SETUP X.X
<SET
SETUP X.X
STEP PCT ELAP REM
MODE
SETUP X.X
<SET EDIT
A-CAL=0.000 LPM
GEN STBY SEQ SETUP
CFG CLK PASS MORE EXIT
EXIT
END OF SEQUENCES
INS PRNT EXIT
EDIT EXIT
PROGRESS MODE:REM
EDIT EXIT
PROGRESS MODE:REM
ENTR EXIT
PROGRESS MODE:ELAP
EXIT
06873E DCN7106