The Purge Step; The Standby Step - Teledyne T700 Operation Manual

Teledyne API – Model T700 Dynamic Dilution Calibrator

4.3.2.4. The PURGE Step

4.3.2.5. The STANDBY Step

06873E DCN7106
This step places the T700 into PURGE mode.
At the end of the programming sequence, the T700 firmware will automatically insert a
DURATION step that needs to be defined.
To insert a PURGE step into a sequence, press:
INSERT STEP Submenu
SETUP X.X
PREV NEXT
SETUP X.X
SETUP X.X
Toggle these
buttons to set
DURATION of this
step
The STANDBY step places the T700 into STANDBY mode. It is recommended, but
not required to follow this with a DURATION step.
To insert a STANDBY step into a sequence, press:
Starting at the STEPS Submenu
INSERT STEP Submenu
SETUP X.X
PREV NEXT
Use the PREV and NEXT buttons to scroll though
the list of available instructions
SETUP X.X
Overview of Operating Modes and Basic Operation
Starting at the STEPS Submenu
INSERT STEP: GENERATE
Use the PREV and NEXT buttons to scroll though
the list of available instructions
INSERT STEP: PURGE
DURATION: 1.0 MIN
0 0 1 .0
INSERT STEP: GENERATE
EXIT
ENTR
INSERT STEP: STANDBY
EXIT
ENTR
EXIT
ENTR
EXIT
ENTR
ENTR EXIT
131