Table 4-3: Test Functions Defined - Teledyne T700 Operation Manual

Teledyne API – Model T700 Dynamic Dilution Calibrator

Table 4-3: Test Functions Defined

DISPLAY
A-CAL
T-CAL
A-DIL
T-DIL
1
O3FLOW
1
O3GENDRV
1
O3LAMPTMP
CAL PRES
DIL PRES
2
REG PRES
A-GAS
T-GAS
BOX TMP
2
PH MEAS
2
PH REF
2
PH FLW
2
PH LTEMP
2
PH PRES
2
PH STEMP
2
PH SLOPE
2
PH OFFST
3
TEST
TIME
1
Only appears when the optional O
2
Only appears when the optional O
3
Only appears when the TEST channel has been activated.
06873E DCN7106
UNITS
LPM The actual gas flow rate of source gas being output by the calibrator.
LPM Target source gas flow rate for which the calibrator output is set.
The actual gas flow rate of diluent (zero) gas being output by the
LPM
calibrator.
LPM Target diluent (zero) gas flow rate for which the calibrator output is set.
LPM The gas flow rate for which the O
mV The drive voltage of the O
°C O generator UV lamp temperature.
3
PSIG The gas pressure of the source gas being supplied to the calibrator.
The gas pressure of the Diluent gas being supplied to the calibrator
PSIG
Diluent pressure.
The gas pressure at the pressure regulator on the O
PSIG
line.
Actual concentration, and in some modes the actual flow rate, of the
source gas in the calibration mixture being generated is displayed.
The Target concentration, and in some modes the target flow rate, of
the source gas in the calibration mixture being generated is displayed.
°C Internal chassis temperature.
The average UV Detector output during the SAMPLE PORTION of the
mV
optional photometer‟s measurement cycle.
The average UV Detector output during the REFERENCE portion of
mV
the optional photometer‟s measurement cycle.
The gas flow rate as measured by the flow sensor located between the
LPM
optical bench and the internal pump.
°C The temperature of the UV lamp in the photometer bench.
The pressure of the gas inside the photometer‟s sample chamber as
In-hg-A measured by a solid-state pressure sensor located downstream of the
photometer.
The temperature of the gas inside the sample chamber of the
°C
photometer.
Photometer slope computed when the photometer was calibrated at the
1.000
factory.
Photometer offset computed when the photometer was calibrated at
ppb
the factory.
Displays the analog signal level of the TEST analog output channel.
mV
HH:MM:SS Current time as determined by the calibrator‟s internal clock.
generator is installed.
3
photometer is installed.
3
Overview of Operating Modes and Basic Operation
DESCRIPTION
generator is set.
3
generator UV lamp.
3
generator supply
3
97