Com Port Testing - Teledyne T700 Operation Manual

Communications Setup and Operation

5.2.3. COM PORT TESTING

Test runs
automatically
176
The serial ports can be tested for correct connection and output in the COMM menu.
This test sends a string of 256 „w‟ characters to the selected COM port. While the test is
running, the red LED on the rear panel of the calibrator should flicker.
To initiate the test, press the following button sequence:
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ
SETUP X.X
PRIMARY SETUP MENU
GAS SEQ CFG
SETUP X.X
SECONDARY SETUP MENU
VARS DIAG
COMM FLOW
SETUP X.X
COMMUNICATIONS MENU
ID INET COM2
COM1
SETUP X.X
COM1 MODE:0
EDIT
<SET SET>
Continue pressing <SET or SET> until ...
SETUP X.X
COM1: TEST PORT
<SET SET> TEST
SETUP X.X
TRANSMITTING TO COM1
SETUP X.X
COM1: TEST PORT
PREV NEXT OFF
Teledyne API – Model T700 Dynamic Dilution Calibrator
CLK PASS
MORE
ENTR
SETUP
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT
06873E DCN7106