Table of Contents
Advertisement
Arbitrary Waveform Generator (Option)
The T3DSO1000 series support an external Arbitrary Waveform Generator (AWG) , which
can easily and quickly provide multiple output waveforms for users. The AWG provides two
kinds of waveforms: the standard waveform and the Arb. The Arb waveform consists of
two types: the system's built-in waveforms and the stored waveforms.
Built-in waveforms are stored in the internal non-volatile memory. It includes: Common,
Math, Engine, Window, Trigo. Users may also edit the arbitrary waveforms using a PC, or
import the waveforms from a USB disk that contains stored edited waveforms.
The AWG is ordered as software, via a software key code, and the generator hardware itself.
The software is ordered as T3DSO1000-FG for the T3DSO1104 and 1204, or ordered as
T3DSO1000A-FG for the T3DSO1202A or T3DSO1302A.
The Function Generator (AWG) hardware is ordered as T3DSO1000-FGMOD-A.
The T3DSO1000-FGMOD and T3DSO1000-FGMOD-A have the same performance
capability except that the -A version has an isolated output and is 20mm longer in length,
being 161.95mm long. The -A version replaces and superceeds the non-A version. The non-
A version is no longer available.
The T3DSO1000-FGMOD and T3DSO1000-FGMOD-A can be used interchangably by any
T3DSO1000 scope that has the -FG software license.
The isolated capability of the -A version is always on. There are no user controls or
programming commands for the isolation functionality, it is always on.
The isolation specification for the T3DSO1000-FGMOD-A is maximum of 42 Vpk.
Note: Both the software key and hardware function generator hardware need ordering to to
have a functioning AWG.
Note: The Arbitrary Waveform Generator option is not available on the T3DSO1102
oscilloscope
The contents of this chapter:
◆
AWG Menu Introduction
◆
AWG Introduction to the Waveform Selection
◆
AWG Function Setting
◆
AWG System Information
◆
AWG System Status and Firmware Upgrade
◆
AWG Remove Device
168 User Manual
Advertisement
Table of Contents
