Photometer Gas Flow Calibration - Teledyne T700 Operation Manual

Calibration and Verification
7.3.6. O

PHOTOMETER GAS FLOW CALIBRATION

3
Note
Make sure that the T700 is
in standby mode.
Toggle these buttons to
enter the correct
PASSWORD
Toggle these buttons to
match the actual flow as
measured by the external
flow meter
206
A separate flow meter is required for the procedure.
To calibrate the flow of gas through the T700 calibrator‟s optional photometer bench.
1. Turn OFF the T700 Dynamic Dilution Calibrator.
2. Attach the flow meter directly to the EXHAUST port of the T700 calibrator.
3. Turn the T700 Dynamic Dilution Calibrator ON.
4. Perform the following steps:
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ
SETUP X.X
PRIMARY SETUP MENU
GAS SEQ CFG
SETUP X.X
SECONDARY SETUP MENU
COMM FLOW VARS
SETUP X.X
ENTER PASSWORD
8 1 8
DIAG
PREV
NEXT
Continue pressing NEXT until ...
DIAG
PHOTO FLOW SENSOR CAL
PREV NEXT
DIAG FCAL
PREV NEXT
DIAG FCAL
ACTUAL FLOW: 1.000 LPM
1 .0 0
Teledyne API – Model T700 Dynamic Dilution Calibrator
SETUP
CLK PASS
MORE
DIAG
ENTR
SIGNAL I/O
ENTR
ENTR
WAITING FOR FLOW
ENTR
0 0 ENTR
An external flow
meter is needed to
EXIT
perform this
operation.
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT discards the new
setting
ENTR accepts the
new setting
06873E DCN7106