Connecting The Communications Interfaces - Teledyne T700 Operation Manual

Getting Started
OPTIONS 48C AND 48D CONNECTIONS
Figure 3-15: Options 48C & 48D Connections, Customer-supplied PSM to Pin 12 (+) & Pin 9 (-)
OPTIONS 48A AND 48B CONNECTIONS

3.3.1.7. Connecting the Communications Interfaces

44
AVOID DAMAGE to valve driver board: Do NOT connect
power supply to JP1 for Options 48C or 48D.
CAUTION
Figure 3-16: Options 48E & 48F Connections
The T-Series analyzers are equipped with connectors for remote communications
interfaces: Ethernet, USB, RS-232, RS-232 Multidrop and RS-485 (each described
below). In addition to using the appropriate cables, each type of communication method
must be configured using the SETUP>COMM menu (see Sections 4.7 and 5).
ETHERNET CONNECTION
For network or Internet communication with the analyzer, connect an Ethernet cable
from the analyzer‟s rear panel Ethernet interface connector to an Ethernet port. Although
the analyzer is shipped with DHCP enabled by default (Section 5.4), it should be
manually assigned a static IP address.
Configuration: (manual, i.e., static) Section 5.4.1.1
Teledyne API – Model T700 Dynamic Dilution Calibrator
06873E DCN7106