Using The T700"S Internal Clock To Trigger Sequences - Teledyne T700 Operation Manual

Overview of Operating Modes and Basic Operation
4.3.1.4. Using the T700's Internal Clock to Trigger Sequences
This display only appears if there are no sequences currently
programmed into the T700.
OTHERWISE ...
SETUP X.X
1) SEQ [NAME], [X] STEPS
PREV NEXT
Deletes the sequence shown
in the message field
Scrolls back and forth between
existing sequences
120
Sequences can be set to trigger based on the T700‟s internal clock. The sequence can be
set up to start at a predetermined date and time. It can also be set to repeat after a
predetermined delay time.
So activate and sequence timer, press:
Make sure that the T700 is
in standby mode.
INS PRNT EXIT
DEL EDIT
Edits the sequence shown
in the message field
Toggle this
button
turn the
TIMER ENABLE
ON/OFF
Teledyne API – Model T700 Dynamic Dilution Calibrator
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ
SETUP X.X
PRIMARY SETUP MENU
GAS CFG CLK PASS
SEQ
SETUP X.X
SEQUENCE CONFIGURATION
PRINT
EDIT
SETUP X.X
END OF SEQUENCES
INS
SETUP X.X NAME:0
EDIT
SET>
Continue pressing SET> until ...
SETUP X.X TIMER ENABLE:DISABLED
<SET SET> EDIT
SETUP X.X TIMER ENABLE:OFF
OFF
SETUP X.X TIMER ENABLE:ENABLED
EDIT
<SET SET>
SETUP
MORE EXIT
EXIT
PRNT EXIT
EXIT
EXIT
EXIT discards the
new setting
ENTER EXIT
ENTR accepts the
new setting
EXIT
06873E DCN7106