The Generate Step - Teledyne T700 Operation Manual

Overview of Operating Modes and Basic Operation

4.3.2.1. The GENERATE Step

Toggle these
buttons to set the
target
concentration.
Toggle these buttons to
set the target TOTAL
FLOW.
(Default = 2.000 LPM)
Toggle these
s to set
button
DURATION of this
step
Note
128
This step operates and is programmed similarly to the GENERATE > AUTO.
At the end of the programming sequence, the T700 firmware will automatically insert a
DURATION step that needs to be defined.
To insert a GENERATE step into a sequence, press:
Starting at the INSERT STEPS
INSERT STEP Submenu
SETUP X.X INSERT STEP: GENERATE
PREV NEXT
SETUP X.X GENERATE:ZERO
SETUP X.X GENERATE:0.0 PPB SO2
0 0 0
Continue pressing this key until the desired
gas type appears
SETUP X.X GENERATE:0.0 PPB CO2
0 0 0
SETUP X.X GENERATE:0.0 PPB CO2
0 .0 0
SETUP X.X TOTAL FLOW = 2.000 LPM
0 2. 0
SETUP X.X DURATION: 1.0 MIN
0 0 1
If the user attempts to generate a source gas type that has not been entered into
the T700's gas library, the sequence will freeze and after a certain time-out
period, stop running.
Teledyne API – Model T700 Dynamic Dilution Calibrator
Submenu
EXIT
ENTR
ENTR EXIT
ZERO
.0 PPB SO2 ENTR EXIT
.0 PPB CO2 ENTR EXIT
0 PCT CO2 ENTR EXIT
0 0 ENTR EXIT
.0 ENTR EXIT
Toggle this button to
scroll through the
available gas types (as
programmed during
initial setup.)
Toggle this button
to to scroll through
the available units
of measure
EXIT discards the new gas type &
target concentration
ENTR accepts the new gas type &
target concentration
EXIT discards the new
flow rate
ENTR accepts the
new gas flow rate
06873E DCN7106