Setting Up The Ports With Multiple Gas Cylinders - Teledyne T700 Operation Manual

Getting Started

3.4.7.2. Setting Up the Ports with Multiple Gas Cylinders

Make sure that the T700 is
in standby mode.
The label for this button
will change dynamically
as the available gas list
is cycled.
Toggle these
buttons to
change the
target
concentration for
the 1st gas.
Toggle these
buttons to
change the
target
concentration for
the 2nd gas
Repeat until all of the
gases and concentrations
in the canister are
entered.
86
When an application utilizes multiple gas cylinders, program as follows (note that the
GENERATE>AUTO menu (Section 4.2.6) differs from that for a single gas (Section 4.2.1):
STANDBY
<TST TST> GEN STBY SEQ
SETUP X.X
PRIMARY SETUP MENU
SEQ CFG
GAS
SETUP X.X
SOURCE GAS CONFIG
O3 USER
CYL
SETUP X.X
CYLINDER GAS CONFIG
PRT2 PRT3 PRT4
PRT1
SETUP X.X
1) NONE
ADD
SETUP X.X
PORT1:NONE
Continue pressing this button until the
desired gas type is reached
SETUP X.X
PORT1:0.0 PPM H2S
0 2
Toggle this button to change
the units of measure for the 1st
gas
SETUP X.X 1) 25.0 PPM H2S
PREV
Continue pressing this button until the
desired gas type is reached
SETUP X.X
0 5
Toggle this key to change the
units of measure for the 2nd gas
SETUP X.X
PREV
Use this button to
delete this gas entry
Teledyne API – Model T700 Dynamic Dilution Calibrator
A-CAL=0.000 LPM
SETUP
CLK PASS MORE EXIT
EXIT
EXIT
EDIT EXIT
ENTR EXIT
NONE
5 .0 PPM ENTR EXIT
DEL EDIT EXIT
ADD
PORT1:0.0 PPM CO
0 .0 PPM ENTR
PORT1:50.0 PPM CO
ADD DEL EDIT
EXIT discards the new
GAS NAME
ENTR accepts the new
GAS NAME
EXIT
EXIT discards the new
GAS NAME
ENTR accepts the new
GAS NAME
EXIT
Use this button to
change this gas entry
06873E DCN7106