Activating A Sequence From The T700 Front Panel - Teledyne T700 Operation Manual

Teledyne API – Model T700 Dynamic Dilution Calibrator
Note
It is generally a good idea to end each calibration sequence with a
instruction followed by an instruction to return the instrument to
mode.
Even if a
always be to place the T700 in

4.3.1.1. Activating a Sequence from the T700 Front Panel

Make sure that
the T700 is in STANDBY
Use these buttons
to scroll though
the list of available
Progress of sequence
reported here in the
format chosen during
sequence entry.
06873E DCN7106
PURGE
is not included, the last instruction in a sequence should
To create a sequence, use the instructions in the following sections to name the
sequence, set its associated parameters and define the steps to be included.
To activate an already programmed sequence from the front panel, press:
mode
sequences
Overview of Operating Modes and Basic Operation
STANDBY
mode.
A-CAL= 0.000LPM
STANDBY
<TST TST> GEN STBY
STANDBY EXECUTE SEQUENCE:A1
PREV NEXT
M700E begins to execute sequence
ACT CAL= 0.000LPM
[Progress Field]
<TST TST> GEN STBY
T700 returns to remains in mode set by last
sequence instruction.
STANDBY
SETUP
SEQ
ENTR EXIT
SETUP
SEQ
PURGE
117