Functional Checks - Teledyne T700 Operation Manual

Teledyne API – Model T700 Dynamic Dilution Calibrator

3.4.3. FUNCTIONAL CHECKS

STANDBY
<TST
Toggle <TST TST>
buttons to scroll through
list of functions
1
Only appears when warning messages
are active.
2
Only appears when an one or more
calibration sequences are programmed
into the calibrator‟s memory.
3
Only appears if optional O
installed.
4
Only appears if optional O
bench is installed.
06873E DCN7106
After the calibrator‟s components have warmed up for at least 30 minutes, verify that the
software properly supports any hardware options that are installed.
Check to ensure that the calibrator is functioning within allowable operating parameters.
Appendix C includes a list of test functions viewable from the calibrator‟s front panel as
well as their expected values. These functions are also useful tools for diagnosing
problems with your calibrator (Section 9.1.2). The enclosed Final Test and Validation
Data sheet (P/N 05731) lists these values before the instrument left the factory.
To view the current values of these parameters press the following button sequence on
the calibrator‟s front panel. Remember that until the unit has completed its warm-up,
these parameters may not have stabilized.
A-CAL=0.000 LPM
GEN STBY SEQ
TST>
generator is
3
photometer
3
If your calibrator is operating via Ethernet and your network is running a dynamic host
configuration protocol (DHCP) software package, the Ethernet will automatically
configure its interface with your LAN. However, it is a good idea to check these
2 1
MSG CLR SETUP

A-CAL=[Value] LPM

T-CAL=[Value] LPM

A-DIL=[Value] LPM

T-DIL=[Value] LPM

O3GENREF

3
O3FLOW =[Value] LPM

O3GENDRV

O3LAMPTMP

CAL PRES=[Value] PSIG

DIL PRES=[Value] PSIG

REG PRES=[Value] PSIG

A-GAS=[Mode/Value/Gas Type]

T-GAS=[Mode/Value+Gas Type]

A-O3=XXXX

T-O3=XXXX

T-FLW=XXXX

BOX TMP=[Value] ºC

PERM1 TMP=[Value] ºC

PERM FLW=[Value] LP
 4
PH MEAS =[Value] MV

4
PH REF =[Value] MV
 4
PH FLW =[Value] LPM

4
PH LTEMP =[Value] ºC

4
PH PRES =[Value] IN-HG-A
 4
PH STEMP

4
PH SLOPE =[Value]
 4
PH OFFST =[Value]

TIME=[HH:MM:SS]
Getting Started
3
=[Value] MV
3
=[Value] MV
3
=[Value] ºC
=[Value] ºC
77