Defining Calibration Source Gas Cylinders; Setting Up The Ports With Single Gas Cylinders - Teledyne T700 Operation Manual

Getting Started

3.4.7. DEFINING CALIBRATION SOURCE GAS CYLINDERS

3.4.7.1. Setting Up the Ports with Single Gas Cylinders

Make sure that the T700 is
in standby mode.
The label for this button
will change dynamically
as the available gas list
is cycled.
Toggle these
buttons to
change the
target
concentration.
Use this button when
changing the gas
type for a single gas
cylinder.
84
To program the T700 calibrator‟s source gas input ports for a single gas cylinder, press:
STANDBY
<TST TST> GEN STBY SEQ
SETUP X.X
PRIMARY SETUP MENU
SEQ CFG
GAS
SETUP X.X
SOURCE GAS CONFIG
O3 USER
CYL
SETUP X.X
CYLINDER GAS CONFIG
PRT2 PRT3 PRT4
PRT1
SETUP X.X
1) NONE
ADD
SETUP X.X
PORT1:NONE
Continue pressing this button until the
desired gas type is reached
SETUP X.X
PORT1:0.0 PPM CO2
5 .5
Toggle this button to change
the units of measure
SETUP X.X
PREV
Teledyne API – Model T700 Dynamic Dilution Calibrator
A-CAL=0.000 LPM
SETUP
CLK PASS MORE
EDIT
ENTR
NONE
0 0 PCT ENTR
1)5.5 PCT CO2
ADD
EDIT
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT discards the new
GAS NAME.
ENTR accepts the new
GAS NAME.
EXIT
06873E DCN7106