Getting Started; Unpacking And Initial Setup - Teledyne T700 Operation Manual

GETTING STARTED

3.

3.1. UNPACKING AND INITIAL SETUP

ATTENTION
Note
06873E DCN7106
This section addresses the procedures for unpacking the instrument and inspecting for
damage, presents clearance specifications for proper ventilation, introduces the
instrument layout, then presents the procedures for getting started: making electrical and
pneumatic connections, and conducting an initial calibration check.
THE T700 WEIGHS ABOUT 18 KG (40 POUNDS) WITHOUT OPTIONS INSTALLED.
TO AVOID PERSONAL INJURY, WE RECOMMEND USING TWO PERSONS TO
COULD DAMAGE INSTRUMENT AND VOID WARRANTY
Printed Circuit Assemblies (PCAs) are sensitive to electro-static
discharges too small to be felt by the human nervous system. Failure to
use ESD protection when working with electronic assemblies will void
the instrument warranty. For more information on preventing ESD
damage see A Primer on Electro-Static Discharge; the manual can be
downloaded from our website at
Help Center > Product Manuals in the Special Manuals section.
CAUTION – Avoid Damage to the Instrument
BEFORE operating instrument, remove dust plugs from pneumatic ports.
Teledyne API recommends that you store shipping containers/materials
for future use if/when the instrument should be returned to the factory for
repair and/or calibration service. See Warranty section in this manual and
shipping procedures on our Website at
under Customer Support > Return Authorization.
CAUTION – RISK of Personal Injury
LIFT AND CARRY THE CALIBRATOR.
http://www.teledyne-api.com
http://www.teledyne-api.com
under
27