Connecting To Agilent Chemstation Systems - Teledyne VISION G2 CLASSIC 6 User Manual

Appendix B: Networking
Vision Dissolution Tester 2
IP Address: 192.168.1.21
Default Gateway: 192.168.1.1
Subnet Mask: 255.255.255.0
Vision Dissolution Tester 3
IP Address: 192.168.1.22
Default Gateway: 192.168.1.1
Subnet Mask: 255.255.255.0
Network Printer (if applicable)
IP Address: 192.168.1.30
Default Gateway: 192.168.1.1
Subnet Mask: 255.255.255.0

Connecting to Agilent ChemStation systems

When connecting Vision G2 instruments to an Agilent ChemStation system it is
required that the PC with the ChemStation software and the 8453 be configured with
correct IP addresses. The following settings are recommended:
Agilent ChemStation Computer
IP Address: 192.168.1.1
Default Gateway: 192.168.1.1
Subnet Mask: 255.255.255.0
8453 UV/Vis Spectrophotometer (configured through bootp)
IP Address: 192.168.1.2
Default Gateway: 192.168.1.1
Subnet Mask: 255.255.255.0
NOTE: Teledyne Hanson Research Dissolution System Drivers version 5.0 are
required for communication with Vision G2 instruments. Vision G2 instruments require
firmware 2.1 or higher.
Vision G2 Testers User Guide—74-108-800 Rev. H—12 June 2019 142 of 158