Connecting To External Devices/Systems; Power Supply; Lan; Usb Peripherals - Teledyne LeCroy T3DSO2000A Series User Manual

7.3 Connecting to External Devices/Systems

7.3.1 Power Supply

The standard power supply for the instrument is 100~240 V, 50/60 Hz or 100~120 V,
400 Hz. Please use the power cord provided with the instrument to connect it to AC
power.

7.3.2 LAN

Connect the LAN port to the network with a network cable with RJ45 head for remote
control.
Follow the steps below to set LAN connection:
Utility＞System Setting＞I/O＞LAN Config

7.3.3 USB Peripherals

Connect a USB storage device (FAT32 format) to one of the USB host ports for data
transfer, or connect USB mouse / keyboard to one of the USB host ports for controlling
the instrument.

7.3.4 Auxiliary Output

When Mask Test is enabled, the port outputs the pass / fail signal, otherwise, it outputs
the trigger indicator.
See the chapter "Mask Test" for more details.

7.3.5 Probes

The T3DSO2000A series oscilloscope supports active probe and passive probes. The
specifications and documents of the probe can be obtained at

7.3.6 Logic Probe

To connect the logic probe: Insert the probe, with the correct side facing up, until you
hear a "click".
To remove the logic probe: Depress the buttons on each side of the probe, then pull it
out.
1.800.561.8187 information@itm.com
www. .com
T3DSO2000A Manual. Page 15