Adding Or Editing O Generator Calibration Points - Teledyne T700 Operation Manual

Calibration and Verification
7.4.2.2. Adding or Editing O
STANDBY
Make sure that the T700 is
in standby mode.
<TST
SETUP X.X
GAS
SETUP X.X
COMM FLOW
SETUP X.X
Toggle these buttons to
enter the correct
DIAG
PREV
214
Generator Calibration Points
3
To add a calibration point to the table or edit an existing point, press:
A-CAL=0.000 LPM
TST> GEN STBY SEQ
SEQ CFG CLK PASS
VARS
ENTR
Toggle these buttons to the place in the
table where the point is to be added or
edited. New Points are inserted
BEFORE the displayed point.
Toggle these buttons to move
between calibration points
parameters
Toggle these buttons to set
the drive voltage
Toggle these buttons to set
the dwell time for the point.
Toggle these buttons to set
the dwell time for the point.
Teledyne API – Model T700 Dynamic Dilution Calibrator
EXIT
Continue pressing
EXIT
DIAG
EXIT PREV NEXT
DIAG
CAL
EXIT
DIAG O3GEN
DIAG O3GEN
DIAG O3GEN
DIAG O3GEN
<SET EDIT
DIAG O3GEN
<SET SET>
DIAG O3GEN
DIAG O3GEN
<SET EDIT
DIAG O3GEN
<SET SET>
DIAG O3GEN
until ...
EXIT
EXIT
DEL PRNT EXIT
EXIT
EXIT
the new setting
the new setting
EXIT
EXIT
EXIT
the new setting
the new setting
EXIT
EXIT
the new setting
the new setting
06873B DCN6388
discards
accepts
discards
accepts
discards
accepts