Front Panel; Front Panel Display; Figure 2-1: Model 401 F - Teledyne 401 Instruction Manual

Teledyne API Model 401 O

2.2 Front Panel

This section describes the operator interface from the point of view of the front panel. The front
panel consists of a 2-line by 40-character alphanumeric display, 8 pushbuttons, and 3 status
LEDs. Each of these features are described in Section 2.2.1.

2.2.1 Front Panel Display

The display is divided into 4 main "fields": the mode field in the upper left, the message field in
the top center, the sample concentration field consisting of the most recent instantaneous ozone
value field in the upper right, and the MENU field which occupies the entire bottom line of the
display. A typical display is shown in Figure 2-1.
The mode field indicates the current mode of the Analyzer. Usually, it shows "STBY ZS ",
indicating that the instrument is in the standby mode and that automatic zero/span checking is
enabled. Manual span checking or calibration can only be performed by pressing the buttons on
the front panel labeled "ZERO", "O
calibration which is displayed only if automatic multipoint sequence is selected (see Section 3.3
for detailed information). Automatic span check only occurs at the preset time. Calibration and
span adjustments are discussed in greater detail in Section 3.6. Table 2-2 lists all the possible
modes in the Analyzer and their meanings.
Photometric Calibrator Instruction Manual, 01124, Rev. J1
3
Figure 2-1: Model 401 Front Panel
GN" or "ASEQ." ASEQ is a sequence of multipoint
3
2-4