Punch Unit B531 (Option); Punch Position Adjustment - Ricoh B064 SERIES Service Manual

Hide thumbs Also See for B064 SERIES:

Table of Contents

3.8 PUNCH UNIT B531 (OPTION)

The position of the punched holes can be adjusted in two ways.

Front to Rear Adjustment

Three spacers [A] are provided with the punch unit for manual adjustment of the

hole position in the main scan direction:

• 2 mm (x 1)

• 1 mm (x 2)

NOTE: One spacer was installed at installation and the remaining spacers were

fastened with a screw to the rear frame of the finisher under the rear cover

and slightly above the lock bar.

Right to Left Adjustment

The position of the punched holes can be adjusted right to left in the sub scan

direction with SP6-113 Punch Hole Position Adjustment. The position can be

adjusted in the range ±7.5 mm in 0.5 mm steps. The default setting is 0.

Press the  key to toggle the ± selection. A +VE value shifts the punch holes left

toward the edge of the paper, and a -VE value shifts the holes right away from the

CÓPIA NÃO CONTROLADA

REPLACEMENT AND ADJUSTMENT

CÓPIA NÃO CONTROLADA

B531R101.WMF

B478/B513/B531

Table of Contents

B246 series B140 series D052 series