Display Set; Sound Set - GRAUPNER S1024 Reference Manual

Graupner mz-32 / mz-16 Help Reference Manual
Graupner recommends leaving telemetry data logging always on when RF is active.
Model Preset – The Widget and Notice fields permit you to save and then recall/load your
specific configurations.
Model Preset – Widget Create your own Widget decks and save them as a preset. Following
each newly created model will use the preset file to display the widgets. Loading a widget
preset will overwrite the current widgets.
Model Preset - Notice – System notices are stored in a notice preset file that contains all
relevant information for system and telemetry information announcements. The messages
can be found in the Special Menu under the Sensor Notice menu. You can create your own
presets by selecting the notifications you would like to use and then save the configuration
via the Notice field. Each newly created model will use the preset file for sensor notices.
Loading a sensor preset, will overwrite the current sensor notices.
Stick Mode Preset – Determines the stick mode used when a new model is created. The
default mode is defined during the initial radio setup or a Factory Reset.
Battery Type – LiPo/LiIo with a cell voltage of 3.7 volts or LiHV with a cell voltage of 3.8
volts. Never set the voltage mode at 3.8 volts when a LiPo/LiIo 3.7 volts battery is used.
G01S1
Scr.Shot – Assign a momentary switch to take a screenshot of any active screen, which is
stored in the Screenshot folder of the SD Card.
Ext-M Sw. – Applicable when using an external monitor such as the Graupner Smart-Box.
Tap on the respective field to assign navigation switches (Input Control) for scrolling
between the screens and changing the sensor display.
G02S1

DISPLAY SET

In the Display Set menu you can control all your
display settings.
Brightness – Set the screen brightness between 1 – 10.
Backlight – Determines the time before the screen will
dim. You can set a time between 5 seconds and always
on. Briefly tapping the power button will undim the
screen. The screen can also be dimmed/undimmed at
any time, by briefly tapping the Power button.
H.Slide – You can assign switches (Input Control) for
paging the display. They will function identical to the
radio arrow keys (top 2 keys left of screen).

SOUND SET

In the Sound Set menu you can assign volume controls
for the various sound sources by tapping on the
respective field.
The Speaker volume is the main volume control for the
radio, while the volume for Voice, Vario, Beeps and the
MP3 player can be individually controlled. The volume
can be adjusted between 0 (Off) and 20.
Tapping on the menu dialog provides additional options
for controlling the sound on your radio.
Page 46 of 51 Help-Ref-EN-V2.7