Sequencer - GRAUPNER mz-24 Pro Programming Manual

Sequencer

Programming the logical switch
In the basic transmitter display, use your finger or the
provided stylus to touch the gear icon labeled "F":
Touch
The display switches to the blue function menu. Touch
the menu item "Sequencer".
Touch
Through the following described menu item "Se-
quencer" ...
... you can activate, through one common switch and
starting from a specifically settable output position,
up to 9 precisely determined one another steps from
up to three servos within 30 seconds.
150 Function menu | general - Sequencer
In this way it is possible to open the cover while a
folding landing gear is coming out from the fuselage,
so as it is easy to program the opening of the landing
gear case with subsequent closing of one cover after
the landing gear leg has extended, or it is even possi-
ble to let the capote open and the pilot turn his head
and great with his hand. Pre-requirement for all of
these actions is that the desired movements have to
be divided in a logical sequence of single movements.
Selection and activation of the control channels
• Channel selection
You can leave the three pre-set channels "CH9",
"CH10" and "CH11" or you can change, by tap-
ping with a finger or with the provided stylus, ...
Touch
... in the active value field, which is actually marked
in blue, the actual setting through the
tons on the right of the display. The available chan-
nels are 5 ... 12, e.g.:
Use the same procedure with the other channel
value fields.
Touch the RES
the blue (and hence active) field to the default val-
ue.
• Activation / deactivation
The control channels specifically required for the
channel sequencing are activated and deactivated
by tapping on the
vice versa, for example:
Notice
In the sub-menu "Sequencer" activated con-
trol channels are consequentially not available
for other uses.
Sequencing
• STEP 0: Setting the output position
+ or – but-
Concentrate the focus on the actually green line or
change to another favorite control channel of the
three available by tapping on the desired channel
value field or the desired line, for example:
Touch
button to reset a changed value in
INH so that ON appears and
Touch