Equipment Setup
1.2
Use
Description
Post-Processed Static Reference on Pillar
The equipment setup described below is to be used for static operations on fixed surveying
pillars.
The receiver and the RX1200 if used can be assembled to make one unit. One connection
is needed to connect the GNSS antenna which is mounted on the pillar to the receiver. The
receiver and the RX1200 can be kept in the container. Note that the receiver can be
programmed with the RX1200 prior to use which can then be omitted from the setup.
•
GNSS antenna is mounted directly using screw fitting. If using stub and adapter, proce-
dures may vary slightly.
•
GNSS antennas are AX1201 or AX1202 GG. Procedures may vary if AT504/AT504 GG
is used.
GPS1200
30