Manual Configuration Commands; Port Channel Load-Balance - Edge-Core ECS2100-10T Reference Manual

Chapter 12
| Link Aggregation Commands

Manual Configuration Commands

Manual Configuration Commands
port channel
load-balance
Guidelines for Creating Trunks
General Guidelines –
◆
Finish configuring trunks before you connect the corresponding network
cables between switches to avoid creating a loop.
◆
A trunk can have up to 8 ports.
◆
The ports at both ends of a connection must be configured as trunk ports.
◆
All ports in a trunk must be configured in an identical manner, including
communication mode (i.e., speed and duplex mode), VLAN assignments, and
CoS settings.
◆
Any of the Gigabit ports on the front panel can be trunked together, including
ports of different media types.
◆
All the ports in a trunk have to be treated as a whole when moved from/to,
added or deleted from a VLAN via the specified port-channel.
◆
STP, VLAN, and IGMP settings can only be made for the entire trunk via the
specified port-channel.
Dynamically Creating a Port Channel –
Ports assigned to a common port channel must meet the following criteria:
◆
Ports must have the same LACP system priority.
◆
Ports must have the same port admin key (Ethernet Interface).
◆
If the port channel admin key
channel group is formed (i.e., it has the null value of 0), this key is set to the
same value as the port admin key
the interfaces that joined the group.
◆
However, if the port channel admin key is set, then the port admin key must be
set to the same value for a port to be allowed to join a channel group.
◆
If a link goes down, LACP port priority is used to select the backup link.
This command sets the load-distribution method among ports in aggregated links
(for both static and dynamic trunks). Use the no form to restore the default setting.
Syntax
port channel load-balance {dst-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip
| src-mac}
no port channel load-balance
dst-ip - Load balancing based on destination IP address.
dst-mac - Load balancing based on destination MAC address.
(lacp admin key
(lacp admin key
– 380 –
- Port Channel) is not set when a
- Ethernet Interface) used by