Honda CR-V 1997 Service Manual page 1374

Troubleshooting
DTC 4-3
CAUTION: Whenever the Ignition switch Is ON
(II),
or
has been turned OFF for less than three minutes,
be
careful not to bump the SRS unit; the .Irbags could
accidentally daploy and cause demage or InJuries.
Try to reproduce the SRS Indicator light:
1. Erase the DTC memory (see page 24-28),
2.
Turn the ignition switch ON
(11),
and check that the SRS
indicator light comes on for about six seconds, and then
goes off.
Does the SRS indkator light stay on1
YES NO
! Intermittent failur ••
system is OK at thl. time. Se.
Troubleshooting Intermittent Failures on page 24-28.
Check for a short to another wire or decreased resistance in
the front passenger's .. at belt tensioner:
1. Disconnect the negative battery cable, and wait for three
minutes.
2.
Disconnect the front passenger's seat belt tensioner 2P
connector from the right side wire harness 2P connector
(see page 24-23), 00 not disconnect the driver's seat belt
tensioner 2P connector.
3.
Connect the special tool (2 OJ to the right side wire har-
ness 2P
connector.
4.
Reconnect the negative battery cable.
5. Erase the OTC memory (see page
24-28'.
6. Read the OTC (see page 24-26'.
Is DTe .... 3 indicated7
YES
NO
Short to another wire or decreased resistance in the front
pu •• nger's seat bett tensioner; replace ttM front passen-
__ ...... belt
Is-
page
24·31.
To
page 24-77
24-76
RIGHT SIDE WIRE
HARNESS
2P CONNECTOR
FRONT
PASSENGER'S
SEAT BELT TENSIONER
2P CONNECTOR
SRS SIMULATOR
LEAOC
07TAZ - SZ5011A
and SRS INFLATOR
SIMULATOR
~1i:...~ACKI
i j _ T f l . W ' 1 A