Taillights; Rear Side Marker Light; Ucense Plate Light - Honda CR-V 1997 Service Manual

Rear Side Marker Lights!
License Plate Light
Replacement
Rear Side Marker Light:
1. Remove the retaining spring. and remove the rear
side marker light from the rear bumper.
2. Disconnect the 2P connector from the light.
2P CONNECTOR
RETAINING
SPRING
SOCKET
~ ~~
\
~~Q1
~~
BUlB----::::!'~.: ' ~ ' <; ~ ::::~1
13CPI ...::
J
HOUSING
Ucense Plate Light:
1. Remove the two screws from the license plate light,
and pull the light out part althe way.
2. Disconnect the 2P connector from the light.
23-82
LICENSE PLATE
lIGHTI8WI
2P CONNECTOR
Taillights
Replacement
1. Open the hatch glass.
2. Disconnect the 6P connector from the taillight.
3. Remove the three screws, then pull out the outer
taillight.
reMcrttt1--------
o--¥+-\t--t+t-Jt<O
~"=:i,-
o-I+.)1-H1{n -- ---;
ttt--Q
6P CONNECTOR
Brake/Parking light: 21/5 W
Back-up light: 21CP
118 WI
Tum signal light: 21 W
TAiLUGHT
4. Inspect the gasket; replace it if it is distorted or
stays compressed.
5. Install the taillight, and run water over it to make
sure
it
does not leak.