Honda CR-V 1997 Service Manual page 1287

Power Door Locks
Control Unit Input Test
1. Remove the driver's door panel (see section 20).
2. Disconnect the 18P connector from the control unit.
3. Inspect the connector and socket terminals to be sure they are all marking good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the connector.
~
If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the control unit must be faulty; replace it.
23-126
KEYLESS/POWER DOOR LOCK
CONTROL UNIT
GRY
BLU
YEL WHT /RED \ WHT /GRN
-........ "' \ t
Wire side of
female terminals
6 7 8
16 17 18
18P CONNECTOR