Passenger's Window Switch Test; Driver's Window Motor Test - Honda CR-V 1997 Service Manual

Passenger's Window Switch Test
1. Remove the inner handle (see section 20).
2. Disconnect the 5P connector then remove the two
mounting screws from the passenger's switch.
PASS£NGER'S
WINDOW
SWITCH~ ~'<.
5P CONNECTOR
CB
~~~
INNER HANDLE
3. Check for continuity between the terminals in each
switch position according to the tabl e.
f\
Terminal
1 2
3 4
5
Position
\
UP
-U
OFF
0- -0 0 -0
DOWN
0 -0
Driver's Window Motor Test
Motor Test:
1. Remove the driver's door panel , and disconnect all
connectors (see section
20).
2. Disconnect the 4P connector from the window motor.
Termi na l side of
male termina ls
3. Test the motor in each direction by connecting bat-
tery power and ground according to the table.
When the motor stops running, disconnect one lead
immediately.
Terminal
\
1 2
Direction
UP
e
®
DOWN $
e
4. If the motor does not run at all or does not run
smoothly, replace it.
PulserTest:
5.
Connect the test leads of an analog ohmmeter to the
No. 3 and No. 4 terminals.
6. Run the motor by connecting power and ground to
the No. 1 and No. 2 terminals. The ohmmeter needle
shquld move back and forth alternately.
23-137