Rear Hatch Glass; Harness Wiring Locations - Honda CR-V 1997 Service Manual

Rear Hatch Glass
Replacement
CAUTION:
• Put
on
gloves to protect your hands.
• Use seat covers to avoid damaging any surfaces.
• DD not damage the rear window defogger grid lines
and terminals.
NOTE: An assistant is helpful when removing the rear
hatch glass.
.: Nut locations
A • • 4 8 •• 4
Harness wiring locations:
REAR WINDOW WIPER
MOTOR CONNECTOR
Remove the rear wiper lower
cover (see page 20·99) .
CLIP
6IC 1.0
mm
REAR WINDOW
DEFOGGER
TERMINAL
9.8 N"" 11 .0 kgf·m.
7.2 Ibf.f"
REAR SPOILER
~~~~
(;7-
HARNESS
CLIP
REAR WINDOW
H~2!If~
TRIM
f
HARNESS
REAR HATCH GLASS
WASHER TUBE HIGH MOUNT
8x 1.25 mm
22 N·m 12.2 kgf·m.
16 Ibf·ftl
8x1.25mm
22 N·m 12.2 kgf·m.
16Ibf.f"
Installation is the reverse of the removal procedure.
NOTE:
• Adjust the reaf hatch glass alignment.
8RAKEUGHT
HIGH MOUNT TERMINALS
BRAKE LIGHT
COVER
• Make sure the connector, terminals and washer tube are connected properly.
• Adjust the aim of the rear window washer nozzle (see page 20·103).
20-78