Rear Hatch Glass Lock Cylinder Replacement; Rear Hatch Glass Actuator Replacement - Honda CR-V 1997 Service Manual

Rear Hatch Glass Lock Cylinder
Replacement
NOTE: Take care not to scratch the tailgate door.
1. Remove the tailgate door panel (see page 20-151.
2. Remove the bolt securing the lock cylinder. Turn
and pullout the lock cylinder, and disconnect the
cylinder rod.
NOTE: Take care not to bend the cylinder rod.
... : Bolt location. 1
($mm>
6 x 1.0 mm
9.8 N'm (1.0 kgf·m.
7.2lbf.ftl
REAR HATCH GLASS
LOCK CYLINDER
3. Installation is the reverse ofthe removal procedure.
NOTE:
• Make sure the cylinder rod is connected properly.
• Make sure the rear hatch glass opens properly.
Rear Hatch Glass Actuator
Replacement
CAUTION: Put on glove. to protect your hands.
NOTE: Take care not to scratch the tailgate door.
1. Remove:
• Tailgate door panel (see page 20-151
• Rear hatch glass lock cylinder
2. Disconnect the connector and the connector clip.
Remove the bolts securing the actuator, then
remove the actuator .
NOTE: Take care not to bend the cylinder rod or
damage the joint.
... : Bott
locations. 3
CONNECTOR
6x 1.0mm
9.8 N·m '1 .0 kgf·m.
7.2 Ibf.ltl
CONNECTOR
CLIP
REAR HATCH
GLASS
ACTUATOR
JOINT
CYLINDER
ROD
..~
3. Installation is the reverse of the removal procedure.
NOTE:
• Make sure the cylinder rod and connector are
connected properly.
• Grease the joint of the cylinder rod .
• Make sure the rear hatch glass opens properly.
20-19