Center Dashboard Lower Cover Removal And Installation; Center Panel Removal And Installation - Honda CR-V 1997 Service Manual

Dashboard
Center Dashboard Lower Cover
Removal and Installation
SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS
section (24) before performing
repairs or service.
CAUTION:
• When prying with a flat~tip screwdriver, wrap
it
with
protective tape, and apply protective tape around the
ralated parts to prevent damage.
• Put on gloves to protect your hands.
Center Panel Removal and
Installation
SRS components are located in this area. Review the SAS
component locations, precautions, and procedures in the
SRS section (24) before performing repairs or service.
CAUTION:
• When prying with a flat-tip screwdriver, wrap
it
with
protective tape, and apply protective tape around the
ralated parts to prevent damage.
• Put
on
gloves to protect your hands.
NOTE: Take care not to scratch the dashboard and related
NOTE: Take care not to scratch the dashboard and related parts.
parts.
1. Remove:
• Driver's dashboard lower cover (see page 20-48)
• Glove box (see page 20-491
• Center pocket (AfT model, see page 20-491
• Center console (M(T model, see page 20-471
• Center upper pocket (M(T model. see page 20-471
2. Remove the screws, and detach the clips, then
remove the center dashboard lower cover.
Disconnect the connectors.
Ii": Screw locattons,·4
1>: Clip locations, 3
ACCESSORY
SOCKET
CONNECTOR
3. Installation is the reverse of the removal procedure.
NOTE: Make sure the connectors are connected
properly.
20-50
1. Remove:
• Driver's dashboard lower cover (see page 20-48)
• Glove box (see page 20-491
• Center pocket (AfT model, see page 20-491
• Center console {MIT model, see page 20-471
• Center upper pocket (M(T model, see page 20·471
• Center dashboard lower cover
2. Remove the bolts, and release the clips, then pull
out the center panel. Disconnect the connectors and
antenna lead, then remove the center panel.
Ii":
Bolt locations, 2
CENTER PANEL
A
A
t>:
Clip locations
A D.. . 8 D, 2
~ ~
AUDIO UNIT
CONNECTOR ANTENNA
LEAD
CUMA TE CONTROL
UNIT CONNECTORS
3. Installation is the reverse of the removal procedure.
NOTE: Make sure the connectors and antenna lead
are connected properly.