Mode Control Motor - Honda CR-V 1997 Service Manual

Mode Control Motor
Replacement
1. Disconnect the 7P connector from the mode control
motor. Remove the rod from the arm of the mode
control motor. Remove the self-tapping screws and
the mode control motor.
MODE CONTROL MOTOR
2. Install in the reverse order of removal. After installa-
tion, make sure the mode control motor runs
smoothly.
Test
1, Disconnect the 7P connector from the mode control
motor.
2. Connect battery power to the No. 1 terminal, and
ground the No.7 terminal. To avoid damaging the
mode control motor, do not reverse power and
ground.
MODE CONTROL MOTOR
.-- .--
.--
r -
I'-' '-'
1'-'
1 2 3
•
5
6 7
3. Using a jumper wire, connect the No.7 terminal
individually to the No.2, 3, 4, 5 and 6 terminals in
that order. Each time the connection is made, the
mode control motor should run smoothly and stop.
If the mode control motor does not run when jump-
ing the first terminal, jump that terminal again after
jumping the other terminals. The mode control
motor is OK
if
it runs when jumping the first termi-
nal again.
4. If the mode control motor does not run in step 3,
remove it, then check the mode control linkage and
doors for smooth movement. If they move smoothly,
replace the mode control motor.
22-41