Honda CR-V 1997 Service Manual page 1349

From page 24-50
I
Check for an open in the cable reel (cont'd):
5.
Reconnect the battery positive cable, then reconnect the
negative cable.
6. Erase the DTC memory (see page 24-28).
7. Read the DTC (see page 24-26),
Is OTC 1-1 or OTC 1-2 indicated?
YES
NO
I
Open or increased resistance in the cable reel; replace
I
the cable reel (see page 24-91
J.
Check for an open in the SRS main harness:
1.
Disconnect the battery negative cable, then disconnect
the positive cable, and wait for three minutes.
2. Disconnect the front passenger's airbag connector (and
disconnect both seat belt tensioner connectors).
3.
Disconnect the SRS main harness 18P connector from
the SRS unit. Do not disconnect the special tool (2
0)
from the SAS main harness.
4.
Check resistance between terminals No.1 and No. 13 of
the SRS main harness 18P connector.
There should be approx. 2.0 - 3.0 n.
Is the resistance as specified?
YES NO
Poor contact at the SRS main harness l8P connector;
check the connector .
• tf
the connector is OK, substitute a known-good SRS
unit, and recheck.
• If the problem is still present, replace the SRS main
harness.
I
Open or increased resistance in the SRS main harness;
I
replace the harness.
SRS UNIT
SRS MAIN HARNESS
18P CONNECTOR
4 5 6 7 8 9 C 8 0 6
Wire side of temale
terminals
24-51