Digit-By-Digit Editing - Siemens SINAMICS V20 Operating Instructions Manual

Digit-by-digit editing

Note
Digit-by-digit editing of parameter numbers or indexes is only possible in the parameter
menu.
Digit-by-digit editing can be performed on parameter numbers, parameter indexes, or
parameter values. This editing method is best suited when large changes are required to
parameter numbers, indexes, or values. For information about the inverter menu structure,
refer to Section "Inverter menu structure (Page 51)".
● In any edit or scroll mode, digit-by-digit editing is entered by a long press (> 2 s) on
● The digit-by-digit editing always starts with the rightmost digit.
● Each digit is selected in turn by pressing
● Pressing
● Pressing
being edited.
● Pressing
● If more digits are required to the left, then these must be added by scrolling the existing
leftmost digit above 9 to add more digits to the left.
● Pressing
Example 1:
Editing parameter numbers
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884
once moves the cursor to the rightmost digit of the current item.
twice in succession exits the digit-by-digit mode without changing the item
on a digit when there are no further digits to the left saves the value.
or for over two seconds enters fast digit scrolling.
Example 2:
Editing parameter indices
If a parameter is an array, edit indices
as illustrated below:
5.1 The built-in Basic Operator Panel (BOP)
.
Example 3:
Editing parameter values
Commissioning
.
55