Normal Editing Of Parameters - Siemens SINAMICS V20 Operating Instructions Manual

Commissioning
5.1 The built-in Basic Operator Panel (BOP)

Normal editing of parameters

Note
Pressing
parameter numbers or indexes is only possible in the parameter menu.
This editing method is best suited when small changes are required to parameter numbers,
indexes, or values.
● To increase or decrease the parameter number, index, or value, press
than two seconds.
● To quickly increase or decrease the parameter number, index, or value, press
for longer than two seconds.
● To confirm the setting, press
● To cancel the setting, press
Example:
Editing parameter values
54
or for longer than two seconds to quickly increase or decrease the
.
.
or
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884
for less
or