Siemens SINAMICS V20 Operating Instructions Manual page 203

Parameter Function
Note: If the SuperTorque function is enabled, the inverter will initially ramp using the value in P3353.
P1061[0...2] JOG ramp-down time [s]
Sets ramp-down time. This is the time used while jogging is active.
Dependency: See also P3350, P3353.
Note: See P1060
P1070[0...2] CI: Main setpoint
Defines source of main setpoint.
Setting: 755
1024
1050
P1071[0...2] CI: Main setpoint scaling
Defines source of the main setpoint scaling.
Setting: See P1070
P1074[0...2] BI: Disable additional
setpoint
Disables additional setpoint.
Setting: See P1070
P1075[0...2] CI: Additional setpoint
Defines source of the additional setpoint (to be added to main setpoint).
Setting: See P1070
P1076[0...2] CI: Additional setpoint
scaling
Defines source of scaling for additional setpoint (to be added to main setpoint).
Setting: 1
755
1024
1050
r1078 CO: Total frequency
setpoint [Hz]
Displays sum of main and additional setpoints.
r1079 CO: Selected frequency
setpoint [Hz]
Displays selected frequency setpoint. Following frequency setpoints are displayed:
r1078 Total frequency setpoint
•
P1058 JOG frequency right
•
P1059 JOG frequency left
•
Dependency: P1055 (BI: Enable JOG right) or P1056 (BI: Enable JOG left) define command source of JOG right or JOG
left respectively.
Note: P1055 = 0 and P1056 = 0 ==> Total frequency setpoint is selected.
SINAMICS V20 Inverter
Operating Instructions, 09/2014, A5E34559884
Range Factory Can be
default changed
0.00 - 10.00 U, T
650.00
0 - 1050[0] T
4294967295
Analog input 1 setpoint
Fixed frequency setpoint
Motor potentiometer (MOP) setpoint
0 - 1 T
4294967295
0 - 0 U, T
4294967295
0 - 0 T
4294967295
0 - 1 T
4294967295
Scaling of 1.0 (100%)
Analog input 1 setpoint
Fixed frequency setpoint
MOP setpoint
- - -
- - -
Parameter list
7.2 Parameter list
Scaling Data Data
set type
- DDS Float
- CDS U32
4000H CDS U32
- CDS U32
- CDS U32
4000H CDS U32
- - Float
- - Float
Acc.
Level
2
3
3
3
3
3
3
3
203